Installation guide

Use this guide for 3D Compmold cork acoustic panels where layout, adhesive, alignment, and final visual quality matter.

Back to installation guide center Order samples Contact CanCork

Use this page when

The product is a 3D cork decorative or acoustic wall panel.
You are creating an acoustic, feature, studio, office, or commercial wall.
You need adhesive, layout, cutting, and environmental guidance.

Before you start

Confirm wall surface is clean, dry, and stable.
Plan panel orientation and pattern before applying adhesive.
Dry-fit panels and check lighting before final placement.

Important

Do not start from a visibly crooked reference line.
Do not install over damp or unstable substrates.
Do not skip final alignment checks as adhesive sets.

Related resources

View wall and ceiling products

Compare 3D, MDF, textured, and tile wall products.

Wall tile guide

Use the wall tile guide for flat cork wall tile products.

Contact CanCork

Ask before installing on unusual substrates or large feature walls.

Detailed instructions

How to Install 3Dcompmold Cork Acoustic Wall Panels

Tools You’ll Need:

Level (spirit level)
Pencil or chalk
Strong, fast-bonding construction adhesive such as:
- Loctite PL Premium Fast Grab
- Gorilla Heavy Duty Construction Adhesive (8010001)
- Bostik Mounting Glue
Utility knife with snap-off blades
Optional: Small nails or pins for temporary panel support

Installation Process

1. Surface Preparation

Make sure your wall is dust-free, dry, and properly primed. A clean, well-prepared surface helps ensure secure adhesion.

2. Measure and Layout Planning

Determine the size of the wall area you’ll be covering. Create a layout plan to decide how the panels will be arranged for a symmetrical and clean look.

3. Mark a Reference Line

Using your level, draw a vertical guideline down the center of the wall. This line will act as a guide for placing your first panel and help keep the rest aligned.

Tip: If beginning from a corner rather than the center, keep in mind that walls are not always perfectly square. This may cause alignment issues or visible gaps as you move across the wall.

4. Apply Adhesive

Apply your selected construction adhesive in spaced-out dabs or lines on the back of each panel. Ensure it is a high-strength, quick-set adhesive suitable for cork and vertical applications. installation instructions for may not stright

5. Attach the Panels

Place the panel against the wall, aligning it with your marked line. Press firmly to secure. Use the level to check both vertical and horizontal orientation.

6. Support While Curing (Optional)

If needed, use finishing nails or pins to hold the panel in place until the adhesive fully sets. This prevents slippage.

7. Trimming Panels

Use a utility knife to cut and fit panels at edges or around obstacles like outlets and corners. Always cut from the back side for cleaner results.

Key Considerations:

Natural Material Flexibility:
Cork is a natural material and may slightly expand or contract with humidity and temperature changes. Allow a margin of ±1 mm during alignment.
Check Each Panel Before Installing:
Test-fit each panel before adhering it. Some minor adjustments may be needed to maintain seamless alignment.
Use Your Level Often:
Frequently check alignment to avoid cumulative drift across the wall.

Environmental Conditions

Room Temperature:
Only install when room temperature is stable and above 15°C (59°F). Drastic temperature changes can affect the panels during and after installation.
Acclimatization:
Let the cork panels sit in the installation area for at least 48 hours. This allows them to adjust to the ambient temperature and humidity.

Final Step: Quality Check

Once all panels are in place, double-check the alignment and adhesion across the entire wall. Make any last-minute adjustments before the adhesive fully sets.

By carefully following these guidelines, you’ll achieve a visually stunning and acoustically enhanced wall that showcases the natural elegance of cork.